Buck converter case, HW-384
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Snap together case for HW-384 buck converter.
- Rating
- 5 / 5
- Likes
- 9
- Downloads
- 155
- Makes
- 1
- Views
- 714
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution
Snap together case for HW-384 buck converter. I prefer PETG because I had problems with PLA tabs snapping off when putting the top on. There are standoffs on the base for wire clearance and ridges in the walls to snap the PCB into. I use these to put buck converters in automobiles where a bare board may contact metal and short. They give me a base to use VHB tape to hold them in place without worrying and are still attractive enough if left visible. I don't put a significant load on the ones I use, so heat isn't an issue for my application, but these are rated for 3A, so your mileage may vary.