Touring Caravan grey water waste pipe support
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Little support brackets/stands for touring caravan waste water pipes.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 46
- Makes
- 0
- Views
- 721
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
Following reading this blog about caravan grey water waste ( https://caravanchronicles.com/2013/05/26/connecting-your-drainage-on-serviced-pitches/ ) I purchased all the parts needed and have been very happy with using it. However, I have found that, if unsupported, the piping tends to sag and then the water doesn't drain well.
So I designed a little waste-pipe-support, and not being very imaginative, I took inspiration from the alphabet.
From just this one design, I printed off about 8 copies using the same model, but in Cura I adjusted only the height of each one to range evenly from about 80mm high, to 180mm high.
They can stack for saving a bit of space when packed up
These completely solved the draining issue.
I printed them in PETG for better weather/UV resistance
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.20mm
Infill:
25%
Filament: Sunlu PETG Assorted
Notes:
You need to rotate it so that it prints on it's side (looking down at the print bed it would look like a upside-down "V")
It may be also wise to add a brim or raft when slicing to aid bed adhesion while printingCategory: Sport & Outdoors