Enlarged Belt guide bearing cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A bearing cover to enlarge the outer diameter of your belt bearings
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 13
- Makes
- 0
- Views
- 167
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
My Ender5 Plus X and Y axis belts have always rubbed the ends of the extrusions, they pass through. No matter how I aligned the tensioners or what belt guide spacers were used the notches on the bottom of the belt would always rub the top of the extrusion and make for ugly prints.
I made these bearing covers to enlarge the outside diameter of the bearing so it would increase the gap between the inside of the belt and the extrusion. The only downside is the stock belts may not be long enough to fit with these installed. I replaced all my belts when I installed these and my Ender5 Plus runs much smoother than ever before.
No additional hardware is required to use these covers.
Print one cover for each bearing.
Slide the bearing into the cover and re-install bearings.
Tension belt as needed.