1 / 4
Headphone Holder for Mic Stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two-piece headphone holder that is intended to be clamped onto a pole, e.g. on a microphone stand
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 73
- Makes
- 1
- Views
- 500
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The attached STL file needs to be printed twice. The two halves are then assembled directly on e.g. the mic stand.
Additional material to clamp the pieces together (suggestion):
- 2 x M3 nuts (in the pictures shown locking nuts with polyamide inserts BN 637 were used)
- 2 x M3x10mm cylindrical screws (e.g. cross-head)
- For better friction, a rubber band can be cut into pieces and glued onto the parts
The model prints fine with 0.12 mm and 0.2 mm layer height. No brim, no raft, no supports needed.
[UPDATE] 17.10.2025
Addition of two bigger designs to fit diameters d=16 mm and d=22 mm respectively. The original design is intended for diameter d=14.5 mm.