10th Gen Intel NUC - 10 Inch Rackmount
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€3.14 – €3.84 net (excluding VAT)
For file: NUC10FNH-rack-front_0.2mm_PETG_MK3S_3h43m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.49 excluding VAT (range midpoint).
- Weight reported by the author
- 42 g
- Print time reported by the author
- 3.71 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
10" Intel NUC Rackmount Kit (1.5U) for 10th Generation and similar NUCs.
- Rating
- 5 / 5
- Likes
- 30
- Downloads
- 401
- Makes
- 1
- Views
- 2,515
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
Intel NUC Rackmount Kit for 10" server cabinets. The NUC is attached to the cage using two VESA mounting screws on the bottom. Alternatively, it can be fixed with a velcro strap.
The front plate has 6 connectors, in which a keystone adapter can be installed. This allows easy access to connectors from the front. Search for “keystone coupler” to find various options.
With the special 1.5U design, you can install two NUCs in 3U without a gap. The mounting screws will perfectly align with the rail, despite being in half position.
This is a two-piece print that is glued together using a rigid triangle-shaped connector. The two-piece design allows for printing without any supports and you are going to have a nice-looking front (with the Prusa Textured PEI Powder-coated Sheet).
To fit the front on the Prusa bed, rotate it by 54°.
I recommend printing in PETG because the weight and heat might deform PLA over time. You might also want to increase the bed temperature if you have problems with the edges lifting up (The edges of the print bed are usually about 5-10°C cooler).
Supported Generation
- 10th Gen Frost Canyon (NUC10FNH*)
- 11th Gen Panther Canyon (NUC11PAH*)