Mountaineer bookends (Sand filled)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bookends filled with sand keep your books where you want them to be.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 27
- Makes
- 0
- Views
- 296
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Bookends with a sporty touch. Look at these girls and boys! Aren't they brave? Climbing up your bookshelf. :-)
The bookends are hollow inside. During a printing pause you can fill them with sand (or salt or sugar). This will give them enough weight to securely hold the books.
The width, height and depth of each bookend is 110/177/172 mm, so they fit on any bookshelf.
Printing information
Design Software: Fusion 360
Slicer: Prusa Slicer
Layer height: 0.20/0.40 mm (0.4/0.6 nozzle)
Infill: Gyroid 10%
Support: none
If you're printing the bookends, remember to pause the process at 135.00 mm in the slicer. Then, gently fill up the bookend with sand (or sugar or salt) until it's around 1 cm away from the top edge. Be careful not to add too much, or else you might end up with a sandstorm once the printer fan kicks in! Finally, make sure to clear away any sand or dust from the surface before resuming the print.
Assembly information
Assembling is a piece of cake. Just slide the climbers into their bookends and voila!
Usually they hold on their own because they have little clearance. If not, a drop of glue will do the trick.
I am looking forward to your Makes! :-)
If you like this model, feel free to check out my others here.
And maybe you would like to support me with a small donation. Feel free to use the support button on the top right of this page. I myself donate one or two Euros to each designer for an interesting model that is worth five stars to me.