1 / 1
A riser for M8Q-5883 GPS module (FreeCAD)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A riser arm for M8Q-5883 GPS module used on HobbyKing X525 quadcopter frame
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 17
- Makes
- 0
- Views
- 126
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Riser ARM for GPS
A 15cm riser arm for M8Q-5883 GPS module used for Hobbyking X525 quadcopter frame.
I had very bad case of magnetic interference for compass embedded in the GPS module, therefore needed to raise it a bit. This arm raises the module about 15cm.
The cap design is taken from https://www.printables.com/model/195173-iflight-xl5-gps-mast-for-m8q-5883.
It is recommended to print the arm in three parts:
- the arm itself
- the upper holder
- the cap for GPS
I used M3 threaded insert to attach the upper holder to the arm and four screws to attach cap to the upper holder.