Ultron 7 Helmet

Ultron 7 helmet I modeled up for a Crimson Cowl costume. I am in the process of printing it now. It took me a while to dial in the PETG settings on my CR10.

***I finished my preliminary print. I need to make a couple of slight adjustments (nudge one of the tools for the circle surrounding the "ear" on one side - it's a tad too deep, and open up the bottom a bit more to make it wearable). I'll do that this weekend. I'll do, what should be, the final print once I get my hands on some more PETG. Matterhackers is flat out of 1.75mm PETG at the moment. Also, my OctoPi crashed about 75% into the print. Tried to guestimate where to start from to finish it off, but misjudged by about ten layers... in the wrong direction. :\

***I've made the adjustments I think will take care of everything. I'll start up another print tomorrow to make sure everything's ship-shape. If it is, I'll upload the final version when the print is complete. Thanks for the patience, folks. :)

***Finally got a good print. MakeShaper's PETG, a raft (due to the amount of very, very tall supports), slow speeds (50mm/s) and a lot of patience. I'll be uploading the final version this weekend. I'll include both the STL and the Fusion 360 files. Forgive my willy-nilly design "process" in Fusion. ;)

Painted the final print with a super gloss black, then a few layers of Spaz Stix Mirror Chrome. Uploaded photos of the drying parts. Will upload photos of the final, assembled helmet once it's done.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

.1 mm

Infill:

Category: Costume