1 / 5
Eleegoo Saturn 2 Vat Lid
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An overengineered lid for the vat of my Saturn 2 8K resin printer that can be locked down with existing screws.
- Rating
- 4 / 5
- Likes
- 13
- Downloads
- 115
- Makes
- 1
- Views
- 819
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
There are a few of these around but I decided to design one specifically for leaving resin in the machine.
The lid is 4 parts printed in PETG or PLA.
Assembly:
- Use 7 x M3 screws (10mm long) - I used cap head but countersink would probably be better.
- Fasten the 2 center screws in bottom to connect the red joiner part to each half of the lid.
- Then Fasten the 4 outer screws to connect the handle through the joiner and square up the lid parts.
- Install the top screw into the handle to hold it down nice and tight.
When installing into Saturn 2 need to loosen screws nearly to then end or task one out.