Weed Puller - 3/4" PVC
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple, effective, low cost weed puller using 3/4" PVC.
- Rating
- 4 / 5
- Likes
- 29
- Downloads
- 89
- Makes
- 2
- Views
- 1,304
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple weed puller using ¾" PVC and 3 ½" 16D Galvanize nails. To remove weeds, push over weed, twist handle and pull.
If your prefer to use ½" EMT use this model: https://www.printables.com/model/461175-weed-puller-12-emt
Cut length of PVC tubing to a comfortable length (36-46").
Hammer nails into tip with the tubing opening facing up. Using another nail, make sure to recess nail heads. Secure to one end of tubing with super glue. Use rivet holes to drill tubing using 1/8" drill bit. Secure with rivets (5/8" x 1/8") or screws.
Secure handle to the other end of the tubing using super glue. Use rivet holes to drill tubing using 1/8" drill bit. Secure with rivets (1/4" x 1/8") or screws.
Depending on your printer calibration, you may need to adjust XY scaling (98%-102%). Use “fit-test” part to determine best fit vs scale. Apply same scaling to other parts.
Print with PLA+ or PETG with at least 4 shells/walls. Print in the orientation provided. No supports required.