1 / 1
Tradrack "beta" 45 angle mount voron
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This mount is made for the annex tradrack beta, to mount it to your voron only need: 4x Tnut 8x m3 bolts 4x m3 nuts
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 88
- Makes
- 1
- Views
- 1,575
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This mount is made for mounting the beta version of the TradRack to your Voron
under a 45 degrees angle
so you can efficiently run your bowden tubes to your TradRack
without putting too much stress on your Bowden with the filament inside
it is adjustable by 1cm to change the mounting width in case someone has a layout that's
only a little off
also, possible to mount it on top without the spacers
needed parts:
4x m3 tnut
4x m3 bolt 15mm
4x m3 bolt 20mm
4x m3 locknut 15mm