1 / 2
(Swim-) goggles case with drain holes
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple Swim-Goggle case with integrated drain holes.
- Rating
- 5 / 5
- Likes
- 36
- Downloads
- 233
- Makes
- 2
- Views
- 1,064
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Sports
- License
- Creative Commons — Attribution
Hardware needed:
4x 6x3mm Magnets
CA-Glue
This Design utilizes 2 filament hinges. Be sure to print the test print and insert a piece of filament first to check if your printers tolerances work for this print. To assemble slide the lid into the body at a 90° angle and insert 2 pieces of filament through the hinges. Then either just cut them flush or melt the ends to secure the hinge. Finally insert the 4 6x3mm Magnets after putting a bit of CA-Glue in the holes. Be sure to put them in the right polarity.