TP-Link OC200 3U Rackmount Adapter for 10-inch Network Cabinets
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.44 – €2.98 net (excluding VAT)
For file: 10inch_RackmountAdapter_OC200_0.6n_0.2mm_PETG_MK3S_2h22m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.71 excluding VAT (range midpoint).
- Weight reported by the author
- 44 g
- Print time reported by the author
- 2.37 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This rackmount adapter is designed to mount the TP-Link OC200 controller in a 10-inch network cabinet.
- Rating
- 5 / 5
- Likes
- 18
- Downloads
- 238
- Makes
- 1
- Views
- 1,493
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
This rackmount adapter is designed to mount the TP-Link OC200 controller in a 10-inch network cabinet. The frame takes up 1 unit of rack space (1U) and is optimized for ventilation to ensure efficient heat dissipation. The adapter can be easily attached to the TP-Link OC200 using two 3mmx8 screws and two 3mm nuts.
Please note that due to the limited print bed size of the Prusa MK3S+, the frame is 4mm shorter than the standard 10-inch size (254mm). To ensure a proper fit, it is recommended that you print the design without a skirt (minimum loops = 0) and use 100% infill for added strength and stability.
Please note that I recommend printing the model with a 6mm nozzle. While tolerances with a 0.4mm nozzle have not been tested, it may not provide the desired results. It is also recommended to remove the model from the printer bed while it is still warm to prevent damage to the coating, as the model has good adhesion to the printer bed.
If you have any suggestions or ideas for improving this frame, please feel free to contact me.