Case for HomeBrew Gen3 PCB Telescope Controller
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a case for the HomeBrew Gen3 PCB -- it has WiFi, Bluetooth, GPS, MUSB, Relay. It controls a Telescope.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 51
- Makes
- 0
- Views
- 366
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a case for Mark Lord's HomeBrew Gen 3 PCB used to control a telescope. You can get more information here:
https://www.cloudynights.com/topic/854327-homebrew-gen3-pcb-wifibtgpsmusbrelay/page-9#entry12560909
I made the case opening a bit bigger than the gadget to ensure that it would fit regardless of your printer's tolerance or calibration. If there's too much wiggle room you can use electrical tape around the gadget to make it a bit wider for a tighter fit. Alternatively you can hot glue the gadget into the case, but doing so may make it more difficult to remove.
If you're going to use this in extreme temperatures I recommend printing in PETG.
You can also print in ABS, but please remember that ABS is prone to shrinkage which may make it more difficult to achieve a proper fit. You may need to play around more with the model to achieve a proper fit.
The STEP files for this model are available for modifications and improvements.