Sofle V2 Case and Stand

Preliminary enclosed case. It is designed for a fully assembled (with bottom plate) Sofle v2 (not rgb) to sit inside it. The bottom plate attaches to the top using m3 countersunk screws and threaded heat inserts. I used 6 x 3 magnets to attach the controller cover and to attach the case to the base. These dimensions as well as the offset to the case edge may have too much clearance. 

I'm likely going to revise this to use smaller hardware and tighter tolerances, but people were interested.

The knobs pictured are found here.

The weights for the base are found here.

I think many of these parts can be found much cheaper on alternative sites, but links were requested

magnets used here.

m3 heatset inserts from this kit

and screws from some other random hardware kit…