Cooler for Prusa i3 mk3/s orig ExtMotor and Noctua fan
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cooler (fanmount and fanduct) for prusa i3 mk3 original extruder motor and Noctua NF-A4x20. Even printer does handle…
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 14
- Makes
- 0
- Views
- 204
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Cooler (fanmount and fanduct) for prusa i3 mk3 original extruder motor and Noctua NF-A4x20.
Even printer does handle heat of steppers well, i noticed that during summer when printing PETG stepper motor gets pretty hot so i decided prolong its lifespan by a bit cooling. After installed this, temperature went down significantly.
This fan does nice flow and is perfectly silent. If you orient its cable to right side from front view to a printer, you can fit it in provided cable holder and lead it with usual printer cable out of extruder and not be bothered with extra wiring. During testing and next three months i just hanged cable on spring lever from above and worked too.
Front plate of motor is left open as you might use extruder visualizer or passive cooler (not needed necessary, especialy after using this cooler).
To complete print you put two pegs in holes (for better allign of parts) and glue them and glue everything together. I used CA glue. When you have all parts together place fan and screw it lightly by nuts to fit (cables facing side with holder channel).
Whole thing you can spread from bottom and side-slide from front of printer on extruder motor body. It should fit nicely with decend tolerance to easily put it on or remove.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.20/0.10
Infill:
does not matter
Filament:
Prusament, PM,Spectrum ,any.. PLA / PETG
Notes:
print upper part and fanduct 1x
peg - 2x
nut - 4x (0.10)
Print main parts on 0.20 and on "upper part" use layer smoothing by reducing layer height in areas of screw threads to 0.10, nuts you can print whole at 0.10. They work even in 0.20 but depends on your printer how thread will be working after printing.
If you cant use layer smoothing print whole upper part on 0.10
I tested PLA as well as PETG.
I would appreciate if somebody would measure his temperatures during PETG print on stepper outside before and after.
Category: 3D Printer Accessories