Gravity Broom Holder - Fully Captive Gear, Extended Range
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
10mm more capacity for larger and slightly smaller objects. Captive gear once installed on the wall.
- Rating
- 5 / 5
- Likes
- 252
- Downloads
- 1,452
- Makes
- 39
- Views
- 4,336
- Reviews
- 40
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Share Alike
Can grab from about 20mm to 37mm diameter, 10mm more range than the original model.
Uses the same stock gear.
The gear gets clipped in place before the Broom Holder is mounted on a wall. Once mounted the gear is completely captive.
No supports required, 0.6mm outer line width and 0.2mm layer height recommended for the overhang to come out nice.
Use thicker extrusion settings for a sufficiently strong model, I caution against using PLA due to creep.
Reference the original model page for more information.
May/7/23 Rev Notes: Tightened up gear captive features, made screw holes slightly larger.
June/25/23 Rev Notes: Added clearance for rubber band on the gear and correct model orientation.
Nov/23/23 Rev Notes: Added some missing chamfers.