Star Lord Gun for 120mm printers

-Old project from 2020

A break up of Star lord's gun originally by Jace1969 that has been scaled up to 140% to make it fit my hand. The main body has been split up into 9 parts which should be able to be printed on a printer with a 120mmx120mmx120mm bed like the Monoprice Select mini. Each piece also has 2 alignment pins to help with the assembly.

There are 10mm and 5mm pins, you will likely need to shrink them slightly due to tolerances and I will update with how many of each you will need. 95% scale appears to be easy to put in and holds the parts well enough. Additionally, this is the left half, you will need to mirror each part in your slicer to make both halves. This has not yet been printed, but I will update with pictures as I print them and create an assembly diagram. If you want to print this, I can send you my hand drawn diagram I used to plan the cuts.

Note: Part 4 has a hole for a pin that leaves a 2mm square gap, it should just take a minute to fill with putty and sand after assembly. I will see if I can alter the model.

Build Order: Will add a visual guide when I finish printing the whole gun

Attach 3 to 4, 1 to 2, and 7 to 8

Attach 3/4 to 1/2

Attach 5 to 3

Attach 6 to 5

Attach 7 to 2

Attach 9 to 6

Repeat for other half and attach halves

Attach Knob A part 1 to part 2 and attach the knob to 9

Attach a Knob B to both 1 and 5

Attach trigger to part 4 if you want it

Print Settings

Printer:

MP select mini

Rafts: 

No

Supports:

No

Resolution: 

0.13127mm

Infill:

10%

Notes:

Not yet been fully printed

How I Designed This ===================

The model was split up in meshmixer by Autodesk. https://www.prusaprinters.org/cut-stl-models-3d-printing-meshmixer/

Category: 3D Printing