1 / 5
Bosch AFS 23-37 Brushcutter wire holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is an holder to change wires of Bosch AFS 23-37
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 34
- Makes
- 0
- Views
- 363
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
A wire holder for Bosch AFS 23-37 electric brushcutter. With this I can use normal 3mm diameter wire with my brushcutter, avoiding bosch expensive spares.
I print it using PETG with a 0.4 nozzle, flat side with the hole layed on the bed.
The screw dimension I'm using is
- 4mm height
- 3mm width
Tight strongly, but not too much or you'll break the thread in the plastic. I used it for 1 hour without any issues, but cannot assure it will work perfectly if the screw is not tight enough.
Please BE CAREFUL! The part will rotate at 7000rpm, use a mask and SAFETY first of all!