1 / 5
USB Dongle Repair for Anker TM137G Wireless Vertical Mouse — image 1
1 / 5

USB Dongle Repair for Anker TM137G Wireless Vertical Mouse

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I purchased an Anker TM137G Wireless Vertical Mouse but the USB dongle was damaged. I verified that the receiver was…

Rating
0 / 5
Likes
5
Downloads
79
Makes
1
Views
378
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution

I purchased an Anker TM137G Wireless Vertical Mouse but the USB dongle was damaged. I verified that the receiver was working, and decided to try to make a replacement piece. I carefully removed the metal by bending the two pushed in tabs up and then set to work in CAD. I used Onshape to build out the geometry and printed it on my Elegoo Neptune 2 printer.

I had to make a version 2.0 to address issues related to supports and add a notch for the board to lock into. (I'm new to CAD and this is one of the very first things I've tried to model, so if it isn't perfect that is probably why.)

After verifying the fit I replaced the metal USB socket and bent the tabs back down. I was going to add some superglue to hold it together, but it doesn't seem to need it.

Overall I'm pleased with the result and figured someone else might need this part. Note that my receiver has a large component (probably for the 2.4Ghz radio) that was not attached very straight, so I made the top of the dongle a bit higher to provide space for it, which means this won't fit in the bottom of the mouse anymore. Not an issue for me, but wanted to disclose this upfront.

Print Settings

Printer:

Elegoo Neptune 2

Rafts:

Yes

Supports:

Yes

Resolution:

Fine (.12)

Infill:

100%

Filament:

Hatchbox PLA


Notes:

First print attempted without supports did finish, but quality was less than desired. Adding supports made a much nicer finish. Rearranging this differently on the print bed might make a difference... YMMV.

Post-Printing =============

I used nippers to remove the support from the cap portion and gave the corners a bit of a snip to make them smoother. Could also do this with a bit of 800 grit sandpaper if you're bored.

I considered adding a few drops of superglue to permanently hold the back of the cap to the base, but so far it isn't necessary with the metal support in place.

How I Designed This

I'm learning how to use Onshape for a class I'm teaching to High School students, so I took the time to practice fixing this dongle.

Several simple extrusions, (Add and remove) and a bit of careful measurement with a cheap digital caliper from Harbor Freight was all I did.

Category: Computer

Tags