Ring Chip Bag Clip

I wanted a chip bag clip, I looked on thingiverse but I couldn't find any I wanted, a lot were a waste of plastic, I don't need it to look like a shark, or anything else when there is a 99% chance that my toddler will just lose it, I was going to design one from scratch but wasn't in the mood (been designing stuff all day) I then found one I liked that is basically what I had in mind but it had a ring on it to make it easier to get on and off and I loved it BUT for stuff like that I like all the edges to be rounded.

So I took the Chip Bag Clip from srwilson58 which I thought was an awesome design and I rounded all the edges to make it nice and smooth. (printed corners can be sharp enough to cut, especially the bottom edge {bed side})

I don't care for sketchup anymore and instead of fighting the mesh conversion and cleanup in Fusion 360 and it was such a simple design I was able to import it into Fusion 360 and trace around it so it can be tweaked, adjusted, etc. the .f3d file is included.

Thank you srwilson58 for the cool design, He gets all the credit.

Printed with:

3 perimeters for strength since it flexes.

0.2mm layer height.

40% infill (really can do whatever you want)

Used clear PETG because that is what was loaded at the time. :-D

Category: Kitchen & Dining