Voron 0.2 / 0.1 PSU DIN Mounting System

I hate VHB tape and try not to use it if possible. I was disappointed to learn that the official mounting directions for the Voron 0.2 use VHB tape to stick the PSU to the bottom panel. I stumbled across The Voron 0.2 Bigger Skirts mod and decided I was going to figure out a way to mount the PSU to a din rail since these skirts allow more vertical room. And so, the Voron 0.2 / 0.1 PSU Din Mounting System was born.

Requirements:

• Voron 0.2 Bigger Skirts - Print all of these pieces except the Front Left side skirt and Front Right side skirt. They doesn't have the side skirts broken out into individual skirts (they come as a pair in the STL), so you will need to either print and discard one or figure out a way to only print the back ones. I may break them out into individual files later and post here to make it easier.
• Print 1 each of “Skirt with mounting tab” and “Skirt with mounting tab mirrored” from this project.
• Print 2 “Din Rail Plate” from this project.
• 2 m3 heat sets. The same ones you use every where else on a Voron 0.1/0.2 build can be used.
• 4 m3x12 bolts.
• A 200mm x 35mm x 6.5mm DIN rail. I specifically designed around these rails: https://www.amazon.com/gp/product/B07GDFDM3H/
• A DIN rail adapter for your PSU. If you are using the Voron 0.2 BOM official PSU, this is the adapter I used: https://www.printables.com/model/314661-din-rail-adapter-for-meanwell-lrs-150-48

Directions:

• Install the 4 heat sets in the 2 skirts in the mounting tabs. 
• Using your m3x12 screws, attach the Din Rail Plates to the skirts.  Make sure orientation is correct with the lips of the DIN rail facing down.
• Mount one side skirt and slide DIN rail into slot.
• Take the other skirt and slide it into the opposite side of the DIN rail. 
• Mount the last skirt to the extrusion.
• Use DIN rail :)

Notes:

• This was tested only on the DIN rails linked above. There is some play in the DIN rail slots that should hopefully account for other DIN rails. 
• The Voron 0.2 Bigger Skirts does not include files for a larger skirt that accommodates a screen. It only has a headless skirt. I plan on using my screen skirt anyway. It will just not be as tall as the other skirts.