FLIR Ex 20mm Lens Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a lens holder for the FLIR Ex cameras, it holds a 20mm lens snugly and fits snugly into the camera.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 24
- Makes
- 0
- Views
- 173
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
This is a lens holder for the FLIR Ex cameras, it holds a 20mm lens snugly and fits snugly into the camera. I made this because the other one available is quite bulky and a little temperamental to get the angle to print clean. This one prints in about 4 minutes by itself but I recommend printing at least 3 at a time to allow cooling.
These are setup for a .35mm nozzle which will produce 2 perimeters through the entire print. I have infill set to 100% as well as concentric infill but it may not be needed at this point because I trimmed it down to force 2 perimeters.
This one is small enough that the camera is almost fully unobstructed except for a little fuzziness at the bottom.