1 / 2
Monoprice Select V2 / Wanhao Duplicator i3 Printer Enclosure Backdoor
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
bracket for enclosure to keep the good stuff in
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 8
- Makes
- 0
- Views
- 150
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
I built an enclosure out of an upcycled table and cut out a hole in the back for cables. I then modified the UK variant of a "Brush Faceplate" for low voltage cabling - single gang. I cut off the bottom and created this bracket to properly hold it in place. Works great for cable management!
Uses M4 bolt and nuts, also used some all-purpose silicon to help seal things up.
Print Settings
Printer:
Maker Select V2
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.2
Infill:
5%
Category: 3D Printer Accessories