Drums (shells) FULL SIZE, composed

                                                                           S I Z E S                                       

                                                  INCHES                                         MM

                                   outer  diam.    x    height              outer   diam.   x  height

BASS  DRUM                  22                     18                            558.8            457.2

FLOOR  TOM                   16                     16                            406.4            406.4

SNARE  DRUM                14                      6                             355.6            152.4

TOM       13                        13                       9                            330               228.6

TOM       12                        12                       8                            304.8            203.2

Dimensions  refer to the most common sizes. In the slicing phase, they can be increased or decreased. In the same way, the connecting plugs can be perfectly calibrated individually. Any gaps will be filled with glue. If necessary, use sandpaper to facilitate the insertion of the plugs and clean the print residue inside the slots with a thin screwdriver or cutter.  Finish all the edges that touch each other with sandpaper to eliminate small printing imperfections.

After applying glue, tie with large office rubber bands to tighten the parts and obtain a solid and compact body. The shell will definitely stiffen after applying the metal circles that block the skins. Apply the metal supports using holes to be made with a drill or possibly with a red-hot tip. With regard to the printing filling, keep in mind that it will have to support the screws of the metal supports.

Note:  thickness of BASS DRUM is 10 mm; the other ones 8mm