Homelite WeedEater
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Choke Lever on my Weed Eater split and was spinning. Took the old lever and designed up a replacement within…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 20
- Makes
- 0
- Views
- 320
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
Choke Lever on my Weed Eater split and was spinning. Took the old lever and designed up a replacement within TinkerCAD.
Took about 15 minutes to print, and did a couple different variants until i got a nice snug fit.
How I Designed This
Broken part on old WeedEater
This Choke Lever was broken on my old Weed Eater, and was just spinning. Simple enough design, so i did some measurements and made it up in TinkerCAD. There are a couple different versions for download, mainly differences for the mounting hole onto the Choke Lever pole. The 5.0mm one fit mine snug, and mine measured 4.7mm. The difference is due to shrinkage of the filament during printing, how well you printer is adjusted (flow rate, slicer settings, under/over extruding, etc.). So, you may need to print a different one to fit yours.
Category: Parts