1 / 5
Improved Magnetic DeWalt bit holder - 6x3mm magnets, easy insertion and removal — image 1
1 / 5

Improved Magnetic DeWalt bit holder - 6x3mm magnets, easy insertion and removal

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remixed bit holder with several improvements. Easier insertion and removal of bits, fits newer models of drill/driver.

Rating
4.875 / 5
Likes
137
Downloads
723
Makes
12
Views
2,626
Reviews
8

Updated at source:

Model information

Category
Tools
License
GNU General Public License v3.0

This is a remix of a very nice design, but updated to improve on a few things:

  • Mounting tabs shortened by ~1mm to fit the DCD805/DCD800 (and possibly other newer model drills/drivers). Should still fit older designs. 
  • Magnets mount via press fit from the bottom with a slight taper on the hole to help with assembly. Designed for 6x3mm magnets, but should also work with 6x2mm. This way, you can hold screws/nuts temporarily on the back.
  • Extra clearance added to the hex holes. Bits should now be a clearance fit held in only magnetically. Original design (at least on my printer) was a friction fit and I found the bits to be a little too hard to remove. 
  • Relief area added to the front section to help align the bits for easier insertion. 
  • Extra clearance added to the screw hole to better accommodate button head M3 screws – I had trouble inserting these in the original design. 
  • Added miscellaneous fillets around some of the sharper corners to (hopefully) reduce some of the stresses. 

Assembly and installation is almost identical to the original. First, remove the small support tabs with either flush cutters or needle-nose pliers. Press fit the 6x3mm magnets into the holes from the bottom. You can do this pretty easily by using the hex end of something like a bit holder/extension. Then just line up the tabs, install the M3 screw, and you're done!

I couldn't shake the bits loose, but they still remove and insert easily by hand. Printed in PLA with 0.2mm layers; no special settings necessary. 

Parts needed:

6x3mm or 6x2mm magnets (x4)

M3x12mm BHCS or SHCS (x1)

Tags