Wire Management for Small Wires
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I needed small wire management in my 3D printer enclosure (https://www.thingiverse.com/thing:3319066) to add some…
- Rating
- 0 / 5
- Likes
- 29
- Downloads
- 95
- Makes
- 0
- Views
- 949
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I needed small wire management in my 3D printer enclosure (https://www.thingiverse.com/thing:3319066) to add some lights. I would be using wires that are 1mm and 1.5mm in diameter. I could not find a design that would work for me, so I designed my own. The wires are held in neat rows with pegs that accommodate two wires stacked one on the other. It can hold 3 pairs of the 1.5mm wire and 2 pair of the 1mm wire. The sections can be fitted together end to end in any configuration. They are designed to be held down with either double-sided tape or as in my printer enclosure with #4 flat head screws (M3 flat head screws should work also). The 1mm wires go into the outside pin rows on either side (the white wire in the photo). I have yet to install these in the enclosure and if the heat in the enclosure heats the wires and softens them so they are no longer retained, I may have to design additional retaining for those that are vertical on the wall and those that are under the roof of the enclosure.
Print instructions
Slicer Settings:
I used Prusa Slicer 2.3 Beta for this with
0.30mm DRAFT default profile with 100% infill
Printer and Filament
Printed on a Prusa MK3s
using Filastruder Veracity Black PETG