Disc Dye jig Orignal and Lite version
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Helps in centering a disc for spin dying on a turntable
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 96
- Makes
- 0
- Views
- 525
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
My original spin dye jig and a lite version that allows for off center dyeing.
After using my previous spin dye jig for a while I started to have some fun moving off of the jig to do off center dyes. I decided to try and come up with a jig that could hold the disc securely like my previous design while being simpler than 2 parts snapping together. I came up with this two piece set that still snags onto the same range of discs as the previous jig.
This jig may fit a bit tight in your turn table. Some users have reported that the holes were too big when I was printing them at the standard 9/32 inch size. If you’re table is too tight take a drill with slightly smaller than 9/32 and run it backwards through the holes. Increase the size until you get a good fit.