1 / 2
Gauge for Prusa MK3/MK4 Nylock / silicone tube bed leveling mod — image 1
1 / 2

Gauge for Prusa MK3/MK4 Nylock / silicone tube bed leveling mod

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple one-piece bed leveling gauge using handle of the hex key as the pointer to the number scale

Rating
5 / 5
Likes
32
Downloads
176
Makes
5
Views
1,685
Reviews
4

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial

Note: If you have a MK4 with the new thermal expansion brackets under the heat bed, you don't need this. Otherwise, read on.

This gauge uses the handle of the hex key as the pointer to a scale showing the elevation change of the heat bed screw in increments of 0.01 mm. After looking at similar gauges, I wanted something that uses less material and has no moving parts.

Prusa's automatic mesh bed leveling creates a perfectly uniform first layer on the build plate, but "level" doesn't equal "flatness". Flatness becomes important if you need to join the surfaces of two parts that were on the build plate. Then flatness imperfections become evident.

The usual way to compensate for flatness imperfections is to replace the eight metal spacers around the edge of the heat bed with Nylock nuts, leaving the metal spacer in the center. Then, using Octoprint or Pronterface to get a 7×7 array of bed elevation data, adjust the screws to minimize the measured differences from the center, then lock the screws in place with the Nylock nuts.

A better way is to use Daniel Schweinert's silicone tube bed level mod (see also the YouTube video). Basically, you replace the 6 mm metal spacers with 10 mm lengths of silicone tube as compression spacers, again leaving the metal spacer in the center. Then there's no need to get under the heat bed to tighten nuts; simply tighten the screws against the compressed silicone spacers. The silicone tubing should be 8 mm outer diameter and 3 mm inner diameter.

Operation

  1. Insert the short end of the hex key into the gauge on the side labeled UP or DOWN, depending on the direction you are adjusting the screw.

  2. Insert the short end of the hex key into the screw head.

  3. Position the gauge so the handle of the hex key points at 0.

  4. Turn the hex key the desired amount. The number scale represents increments of 0.01 mm.

Print settings

Printer: Prusa I3 MK3S

Resolution: 0.3 mm layers

Infill: 15% gyroid

Filament: PLA

Notes:

For an easy-to-read number scale, set the slicer to pause for changing to a different color filament at the third layer from the bottom (just before the layer that covers up the text), and change back to the original color on the layer at the top where text appears.

 

 

Category: 3D Printer Accessories

Tags