Negative trash rattle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A rattle made from parts of support and failed prints. Makes negative trash.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 47
- Makes
- 0
- Views
- 318
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Share Alike
WARNING: not recommended as a first print (because it requires trash that your 3d printer makes when printing)
print instructions
This model does require a good layer adheasion and a lot of perimeters/infill. Set your slicer to pause the print near the end, because you need to insert stuff into it, before the hole closes. If you downloaded the 3mf and use Prusa Slicer, it's already done. Please, make sure that your printer will move the extruder out of the way, so you can insert stuff. Print it. When it pauses, insert parts of failed prints and supports into the hole. If you are using the version with holes, make sure to use trash that doesn't fall through the holes. Continue the print. If you mess it up and it detaches from the bed, turn off the printer and seal it with duct tape instead.
If the handle breaks, fix with duct tape.