Bugman Wreath Remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bugman Wreath Remix I modified the file to require zero support and zero infill (except for the top layers)
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 9
- Makes
- 0
- Views
- 157
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Bugman Wreath Remix I modified the file to require zero support and zero infill (except for the top layers)
I printed this with a 0.6mm nozzle at 0.3mm then 0.12mm at 112mm and 0.08mm at 130mm
first 4mm with hex infill no bottom layers. add rigidity and gives you hanging points.
The rest of the model is hollow around 80% I switch to 0.12mm and then at the top last 5% or so I switch to 0.08mm
3 perimeters. 2 just won't “close” the top properly. you might be able to get away with 2 with a 0.8mm nozzle. 18 top layers
Mass is under 100g each segment I am coming out around 75g with PETG. this probably won't work well with PLA if used outdoors. need the infill for thermal integrity but not for PETG
This should work well with transparent/translucent filaments.
This is about 200% of the original. scale as you see fit should work fine.