Sovol SV06 Double 5015 High Airflow mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remixed nozzle for the Double 5015 fan mod for significantly less back pressure and greatly improved cooling.
- Rating
- 5 / 5
- Likes
- 28
- Downloads
- 171
- Makes
- 1
- Views
- 1,809
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Warning: Read all instructions prior to installation, especially the part about the screw length!
A remixed nozzle for the Double 5015 fan mod for significantly less back pressure and greatly improved cooling. I liked the original nozzle, but I could tell it was restricting flow quite a bit. This new nozzle makes a huge difference.
This version keeps 100% of your X axis range.
Translation of original fan duct installation instructions from German:
To attach the two 5015 fans you need 4x M4x20 pan head screws, to assemble both parts you need 2x M3x12 cylinder head screws, the corresponding nuts are mounted in the clearances in the fan duct base, see (Figure 8).
---
You can only use countersunk screws M3x23 (image 6) to mount the fan duct base on the printer, these are not available as standard, you have to shorten them from longer screws, the maximum length is 24mm, you will also damage the circuit board on the print head during assembly!!! !!!
Therefore I assume no liability! What you do, you do at your own risk!!!
I printed this in ASA with supports on the bottom section of the duct. I recommend 0.15mm layer height or smaller (I used variable, as small as 0.05mm layer height).
Video of it in action: