The Owl House Stringbean Palisman collapsing staff
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stringbean Palisman from The Owl House with collapsing staff. Remix of a model by LucasGeorge3D
- Rating
- 4.667 / 5
- Likes
- 110
- Downloads
- 601
- Makes
- 2
- Views
- 3,545
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Noncommercial
This is a model of Luz's Palisman Stringbean from The Owl House with a collapsing staff.
It is 83mm wide, 183mm long and 268mm tall. With the staff fully extended, it is about 1.4m tall.
This remix is based on Stringbean Palisman - The Owl House by LucasGeorge3D. The changes are:
- Added a collapsing staff
- Modified the the geometry a bit to make room for the staff
- Added a door at the bottom which can open and close to hide the staff when retracted
- Split everything into parts according to their color
- Added a simple stand
Print Instructions
This print requires blue, white, purple, and green filament. Everything was printed at 0.2mm layer height.
In splitting this model into parts, I've tried to balance minimizing both supports and seams between parts. The parts are:
| Part | Color | Supports | Other |
|---|---|---|---|
| toh stringbean-head_blue | blue | yes | - |
| toh stringbean-body_blue | blue | yes | - |
| toh stringbean-tail_blue | blue | yes | - |
| toh stringbean-head_white | white | yes | adaptive layer height |
| toh stringbean-body_white | white | yes | - |
| toh stringbean-tail_white | white | yes | - |
| toh stringbean-staff_blocker_white | white | no | - |
| toh stringbean-head_purple | purple | yes | adaptive layer height |
| toh stringbean-body_purple | purple | yes | - |
| toh stringbean-tail_purple | purple | yes | - |
| toh stringbean-staff_purple | purple | no | seam position random |
| toh stringbean-head_green | green | no | adaptive layer height |
| toh stringbean-orb_green_left | green | yes | adaptive layer height |
| toh stringbean-orb_green_right | green | yes | adaptive layer height |
| toh stringbean-stand | any | no | - |
Adaptive layer height is recommended for parts with low slopes to make layers less visible.
For the staff, I recommend setting the Seam Position to random. Otherwise, the seams will form a very obvious line along one side of the staff.
If you want to support me, you can do so via this link: https://ko-fi.com/printingdaniel#