1 / 1
SOVOL SV07 Extruder Ribbon Cable Support Extension
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adds extra support for your cable!
- Rating
- 5 / 5
- Likes
- 81
- Downloads
- 983
- Makes
- 13
- Views
- 3,187
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
…Please be sure to hit like & post a make, I'd love to see your prints!
Print on its flat EDGE as this will provide the strength you need in this orientation, that's important!
Don't print too fast or you could pull it off the bed, use a brim!
Make sure your Z offset is good!
Add supports under the overhang.
It does print like this so please don't leave a bad review just because you had trouble printing it. I've tried to keep it as small & lightweight as possible so not to add too much to the moving mass of the extruder.
PLA+ @0.2mm