cr30 - 22.5 degree Micro Swiss NG Adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is an adapter to allow you to put a Micro Swiss NG Revo onto your CR-30 3D Printer.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 131
- Makes
- 0
- Views
- 1,096
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This is an adapter to allow you to put a Micro Swiss NG Revo onto your CR-30 3D Printer. In order to get the Revo to touch the bed, and to improve print quality the entire shebang is angled at 22.5 degrees - so that the extruder splits the difference between the 45-degree-angled printing plane and the flat bed.
Installed, tested and working!
Now includes a modified fan shroud.
The fan shroud is a bit short for the Revo Belt nozzle, but it does work amazingly well. You'll need 5 M3 hex nuts to be pulled captive into the part, and 7 M3 screws to attach it. All the screws I used were M3 by 10mm long.
I bought the CR-10 version of the Micro Swiss Revo NG, and removed the aluminum CR-10 mounting plate.
The adapter needs 5 M3 nuts - put them in first.
Second, attach the adapter to the CR-30 - you'll need to remove the existing hotend.
Third, use three M3 by 10mm screws to attach the Revo NG to the adapter plate. The nozzle should be in almost the exact same spot as the original Creality hotend.
Finally re-wire the machine and get printing! You can even fit the stock Revo fan shroud on, but it only uses one of the two cooling fans from the CR-30.