1 / 2
Flexible TPU Feuchttücher Box / Flexible TPU toilet wipes box — image 1
1 / 2

Flexible TPU Feuchttücher Box / Flexible TPU toilet wipes box

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Flexible TPU Feuchttücher Box 162mm x 114mm h=70 mm Flexible TPU toilet wipes box

Rating
0 / 5
Likes
28
Downloads
199
Makes
0
Views
2,022
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Eine einfache flexible TPU WC Feuchttücherbox die nicht bricht wenn sie mal runterfällt oder oft runterfällt… 

Ich habe das ganze mit einen TPU 95A Filament von Amazon gedruckt.

Dabei habe ich das Fillatech FillaFlex40 Profile im Prusa Slicer verwendet und die Drucktemeratur auf 215° Celsius verringert. 

Das Bett hab ich ein bisschen heißer gestellt 55° und das ganze auf einen strukturierten Blech ausgedruckt. 

Geht natürlich auch mit dem glatten Bech aber mit Klebestift oder Klebespray…sonst geht das fast nicht mehr herunter…

Für das Gelenk habe ich anstatt einer Schraube und Mutter einen kleine Stange mit Verdickung konstruiert.

Ich hab's mit PETG gedruckt, geht aber sicher auch mit PLA …aber mit Support und Umrandung/Brim drucken.

Einfach als erstes durch die Löcher vom Deckel stecken und dann die Löcher der Basis rüberschieben/drücken. Ich hab dazu auch das Gelenk ein bisschen mit Silicon-Fett eingeschmiert da gehts dann eigentlich sehr leicht aber hält.

Ansonsten kann man natürlich auch zwei Schrauben mit M3x12 mit Sicherungsmuttern nehmen.

 

A simple flexible TPU toilet wipes box that won't break if dropped or dropped often...

I printed the whole thing with a TPU 95A filament from Amazon.

I used the Fillatech FillaFlex40 Profile in the Prusa Slicer and reduced the print temperature to 215° Celsius.

I made the bed a bit hotter at 55° and printed the whole thing out on a structured metal sheet.

Of course, you can also use the smooth mug with a glue stick or glue spray...otherwise it's almost impossible to get off...

For the joint I constructed a small rod with a thickening instead of a screw and nut.

I printed it with PETG, but I'm sure it would also work with PLA ... but print with support and border/brim.

Simply put it through the holes in the lid first and then push/push over the holes in the base. 

I also lubricated the joint with a bit of silicone grease because it's actually very easy but holds up.

Otherwise you can of course also use two M3x12 screws with lock nuts.

Tags