Bike mudguard holder parts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bike rear wheel mudguard holder parts
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 56
- Makes
- 0
- Views
- 972
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Parts for creating a mudgard holder for bike rear wheel. Originally designed for a Zefal's Trail Teen 60 mudguard set for installation on Merida Dakar 624 teen bicycle (24" wheel), but should fit for other wheel sizes as well if changing the length of a pole.
There are:
- 1x front mudguard to frame connector
- 1x left side mudguard connector
- 1x left side frame connector
- 1x right side mudguard connector
- 1x right side frame connector
Designed for a 4mm steel pole/spoke to hold and connect rear wheel mudguard to bike frame. Requires:
- 6x M3x3 hot melt nuts
- 6x M3x10 (M3x12) sunk screws
- 2x M5x12 (M5x16) sunk screws
Front connector requires supports. Other parts are simple and can be printed without supports. For higher rigidity side mudguard cnnectors should be placed with a flat long side to the table like shown on the screenshot attached.
My version is made of CF PETG, but i think normal PETG would be fine.