1 / 5
Ultimaker Original+/2/2+ Rear Mounted PSU IEC/USB/RJ11 Connection Panel — image 1
1 / 5

Ultimaker Original+/2/2+ Rear Mounted PSU IEC/USB/RJ11 Connection Panel

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Securely mount connection sockets for IEC power, USB A, USB C, and RJ11 CANBUS through the back panel of the Ultimaker.

Rating
0 / 5
Likes
6
Downloads
21
Makes
0
Views
349
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

The connection lets you easily connect and disconnect your cables from the printer without risk of damaging the sockets on the printer motherboard. 

Attach this connection holder to the back of your Ultimaker over the existing connection holes. You will need to move the printer motherboard location and mount the power supply unit brick underneath the printer as well. If you are going to change up the bottom of your Ultimaker, you should consider upgrading the motherboard and electronics of the printer while you are at it. I upgraded the printer to use a BTT Octopus Pro motherboard and LRS-350-24 PSU.

The panel mounts through 1 existing screw hole and needs 1 new 3mm hole to be drilled. 

You will need a generic IEC panel switch mount with horizontal mounting holes (as seen in the picture) for the power connection. 

Depending on your motherboard connection, you can screw in a USB C or USB A panel mount extension cable to mount in the holes. 

The larger opening is sized for a generic push fit female-to-female RJ11 port used for CANBUS connection options. 

Tags