ID Card Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Card holder for ID cards of approximate size 85x54mm and 0.75mm thick.
- Rating
- 0 / 5
- Likes
- 29
- Downloads
- 78
- Makes
- 1
- Views
- 901
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
Here is an ID card holder for cards of size approximately 85x54mm and 0.75mm thick. The holder has minimal card bordering allowing the card content to be fully displayed. The ID card can be instantly installed or removed from the holder, too; especially convenient for cards that need to be often removed, inserted or otherwise.
The holder is intended for portrait card display. The lanyard clip hole can take clips up to 4mm in diameter.
My print is made in 1.75mm eSUN PLA Plus Orange filament, with 0.2mm layer height and 15% infill on a PRUSA I3 MK3S printer. Print supports are not required.
I hope you can find this print useful, too.