1 / 5
Filament Spool holder Jun 2023 / no bearings no screws needed / smooth, low friction — image 1
1 / 5

Filament Spool holder Jun 2023 / no bearings no screws needed / smooth, low friction

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix. Easier to print Looks aesthetically better Less plastic required Cleaned from artifacts and non-manifolds

Rating
3.75 / 5
Likes
25
Downloads
200
Makes
4
Views
1,099
Reviews
4

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

I tried this model as I didn't want to use any bearings and screws as most of the solution require. And I was really impressed by how smooth and low friction it is. 

However it had some problems and artifacts, also shape was not perfect and a bit wasteful on filament. Roller was not flat and hard to print clean. I adjusted and remodelled everything to address my concerns.

Difference from original:
  • Easier to print (flat roller - no issue with severe overhang and no supports needed)
  • Less plastic required (adjusted the shape keeping same strength but less volume)
  • Lower profile (roller is closer to the base)
  • Click in wheel
  • Bite teeth on the base to hold rail in place

Use provided Bambulab project files, all infills are pre set up in there to optimize the print time and amount of filament used

Same as in original file you have to glue roller together.

 

Tags