Etherpull
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.16 – €0.19 net (excluding VAT)
For file: Etherpull_0.2mm_PLA_MK3S_14m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.17 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 13.8 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A simple cap to simplify pulling ethernet cables without breaking the plastic latches.
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 55
- Makes
- 1
- Views
- 601
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- GNU General Public License v2.0
This tiny shield fits over the end of an ethernet cable to transform it temporarily into a thing that can be easily pulled through any obstacle course of cables and equipment. It prevents the small latch from catching on anything, so it won't break off in the process. And it also prevents the square back end of the connector from catching on things. It can't fall off while being pulled. The connector can fit in either orientation.
It prints easily without supports but I use a 4mm brim for stability. It prints fast: 14 minutes at 0.2 layer height. Works fine in PLA and probably works fine in any but the most flexible filaments like TPU. Typical cost of printing one in inexpensive filament is 3 cents.
I have broken so many of those little plastic tabs that hold ethernet cables in place. Without the tiny tab the cable is a nuisance. Yes, I've taped them in place. Yes, I've rebooted my computer because it came loose. Yes, I know better. Yes, I used some bad words I usually reserve for taxes and Fusion 360.
This is my revenge: anyone with a printer is 3 cents of filament and 14 minutes away from not breaking any more of them.
There is also one of these for USB cables here:
https://www.printables.com/model/506000-usbpull