1 / 3
Almost Print In Place Clamp
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Design initially made to fix H4N recorder on a 50mm diameter tube
- Rating
- 0 / 5
- Likes
- 27
- Downloads
- 79
- Makes
- 0
- Views
- 707
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- GNU General Public License v3.0
This model was initaily design to attach a H4N recorder and its external battery on a 50mm round bar. As it use standard UNC screw almost any device can be attached with it (Go Pro, camera, camcorder, … )
It perfectly fit on round bar from 45mm to 60mm diameter.
Why “Almost Print in place” ?
The main part contains 4 pieces which printed at once avoid the use of support. Knob and spacer then are printed separately.
Print settings :
All Stls are already oriented. Settings below must be respected : Internals lines were added to increase stiffness.
- Material : ABS/ASA is best choice but it can be done with PLA
- No support at all !
- Line width : 0.4mm
- layer height : 0.2mm
- Nb of perimeters : 4
- Top/Bottom : 5 layers
Bill of material:
| Type | Reference | qty | Notes |
|---|---|---|---|
| Hardware | M6x70mm hex head screw | 1 | Metric screw |
| Hardware | ¼ UNC 1" BHCS | 1 | Imperial screw |
| Hardware | M6 Hex nut | 1 | |
| Hardware | M5 Hex nut | 1 | for battery holder |
| Hardware | M5x16mm BHCS | 1 | |
| Hardware | Foam tape 3mm thickness x 15mm wide | 10cm |
Why so many different screws ?
I design with the screws I own or recover
Assembly :
- Put the M6 nut into the knob,
- Insert M6 x 70 screw into the clamp main part. ensure the hex head fit the print part reservation (see picture below)
- Put the knob spacer and screw the knob.
- Then attach your Recorder, camera, … battery on the two left holes.
- Put the foam inside the clamp