Japanese Saw Storage System
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€7.76 – €9.48 net (excluding VAT)
For file: Handsaegen_halter_all_0.2mm_PETG_MK3SMMU2S_9h11m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €8.62 excluding VAT (range midpoint).
- Weight reported by the author
- 103 g
- Print time reported by the author
- 9.18 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A modular system to store your japanese saws of any size in a drawer
- Rating
- 0 / 5
- Likes
- 33
- Downloads
- 101
- Makes
- 0
- Views
- 1,110
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
Japanese hand saws are sometimes very expensive tools and require a certain amount of care when stored. The usual Japanese way of storing them in a fabric roll-up bag is very gentle and practical for travelling, but if like me, you only use the saws in the workshop, it is also very inconvenient.
This system is much more practical because you can take the right saw out of the drawer immediately and then put it back again.
The system consists of the following components:
- System rail long with row drilling for M4 screws to take the brackets and holes for fixing in the drawer.
- System rail with row drilling for M4 screws to take the brackets and holes for fastening in the drawer
- Large saw blade holder for larger saws
- Small saw blade holder for smaller saws
- Holder with support for handle - large
- Holder with support for handle - small
The holders can be fixed to the system rail with an M4x10 screw in a 15 mm grid. The holes do not have a printed thread, so it may be necessary to pre-cut the thread.
For fastening the rails, holes for 3.5 mm countersunk wood screws are provided in the rails. The screws are recessed so far that the sensitive teeth of the saws cannot come into contact with them.
The project file contains all parts (single) with the big rail set to unprintable, while the gcode only contains one piece of all holders and the short rail. you can simply change, rearange or multiply the parts in the 3mf-file for your needs.