Revolving Paint Rack 36mm x 18
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Craft Paint Rack made per request to hold 18 bottles 36mm in diameter.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 37
- Makes
- 1
- Views
- 565
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Standard Digital File License
***Disks needed to be updated to space bottles apart more. If you printed the old versions of discs (24x or 30x) and the bottles collide, my apologies. I will update the model and try to only change the DISK. Tried squishing 30 bottles into a rack that can be printed on a 220x220 build plate, unfortunately it didn't work out as planned.***
!!Working model UPDATED!!
Disk v1.4 is the final rendition & replaced the disk locks with a Disk Sync.
Disk Sync uses 6 pieces of 1.75mm filament to lock in place(recommend melting or gluing in place)
Also updated the crossbar for a little more clearance but I don't think its necessary to reprint
------------------------------------------------------------------------------------------------
Craft Paint Rack made per request to hold 18 bottles 36mm in diameter.
Everything should be printable without supports minus the 3x Buckets & Disk Sync
1 washer goes in between each DISK & A-Frame but may not be required.
Align disks with Disk Sync by matching letters A & B on each disk then sticking short pieces in the alignment moles.
I recommend gluing the disks to the sync bar then melting the filament with a soldering iron & sand smooth if necessary.
---Print the following---
3x Bucket
2x A-Frame
1x Disk A v1.4
1x Disk B v1.4
1x Disc Sync
2x Knob Lock
2x Washer
2x Cross Bar
---Hardware Needed---
12x m5 heat-serts
2x m6 heat-serts
12x m5 bolts ~20mm long
2x m6 bolts ~20mm long
6x scrap filament pieces (1.75mm)
I will update the hardware list with exact length heat-serts & bolts once printed & assembled.
Design is available for a limited time.