Nerf Pathfinder Short Dart Mod

These parts are a remix from gmg081 on thingiverse. Gary designed an awesome kit I tweaked the barrel mount and the pusher slightly. I added an extra mounting point in addition to extra material to prevent over insertion of the magazine.Barrel mount will use m3 hardware (M3x12mm)  to clamp the barrel in place instead of using heat set inserts. There is no mag release so the mags are a little snug to keep them in place.  I have used this setup in several battles and the mag never fell out. I uploaded Gary's instructions to get you started on the case trimming that will be needed for this kit to work.  I glued the pusher to the plunger tube from the inside of the plunger tube.  If you glue the pusher from the outside of the plunger tube the darts will not feed correctly since the pusher will be too far forward.