Tablet and Notebook Stand - Remix
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.74 – €0.90 net (excluding VAT)
For file: TH Beams_0.3mm_PLA_MK3S_45m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.82 excluding VAT (range midpoint).
- Weight reported by the author
- 12 g
- Print time reported by the author
- 44.4 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A Remix of Virus4711's 100% printed adjustable tablet and notebook stand.
- Rating
- 0 / 5
- Likes
- 48
- Downloads
- 191
- Makes
- 0
- Views
- 2,128
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial
Based on Virus4711's wonderful design & precise instructions for his Tablet and Notebook Stand, with some changes for aesthetic preferences, an added “lip” on the upper arms to hold the tablet and different slicing parameters.
True: anything with 100% infill and 3 perimeters will have greater strength than with 15% infill and 2 perimeters. The question I tried to answer with this remix is what is the minimum strength required for a use case. So far, the table below is the first answer.
For example, the brackets with 3 perimeters and 0% infill can be as strong as with 100% infill. (There are many videos on perimeters vs infill on YouTube on the subject).
I used Prusa Slicer 2.6 which also has some improvements in gcode for print time.
Work in progress: notice in the photos that I glued together 2 baseplates. One with only 2 “outside fingers” and one with 3 “inside fingers” added for a total of 5 “fingers”. Any of the two provide enough support and stability on their own, but I'm testing options to eliminate a little bit of torsion generated from my tablet weighing in at 585g.
Note: the tablet is an e-ink Android tablet, the Boox Note Air 2 Plus, to which I added an enclosure with handles for a specific therapeutic use case I documented on Hackster.