5015 fan mount over 4010 fan holes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A way to replace a 4010 hot end fan with a 5015 blower. Intended use is to eliminate heat creep on a all metal hot end.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 54
- Makes
- 0
- Views
- 265
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to replace a 4010 hot end fan on a Mini-Satsana fan duct with a 5015 to eliminate hot end creep when printing lower temperature materials on an Ender 3 with all metal hot end. The slant was to allow continued use of the BL-Touch mount that used the bottom two screws on the 4010 fan. It also directs air flow down the length of the hot end heat sink.
The mount is 5mm thick, so in my case that will alter the probe mount offset by 5mm closer to the nozzle.
The blower output should fit down into the mount opening.