1 / 1
Motor Retainers BT-20 and BT-50 Estes compatible — image 1

Motor Retainers BT-20 and BT-50 Estes compatible

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

These motor retainers are designed to be interchangeable with Estes BT-20 and BT-50 motor retainers.

Rating
0 / 5
Likes
20
Downloads
200
Makes
0
Views
715
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial

If you would like to show some gratitude for this model and encourage me to create more, you can leave a tip for me via PayPal at https://www.paypal.com/paypalme/Arogen67.  Thanks.

These motor retainers are designed to be interchangeable with Estes BT-20 and BT-50 motor retainers, so if you have lost a cap, you can just print a replacement and use that.  If you have an extra cap for some reason, you can print a base to pair with it.

The base glues onto the body tube and the cap screws on to keep the model rocket engine in place.

I included a taller version of the cap because I like to glue a thrust ring in the body tube so ¼ inch of the motor sticks out past the end of the base, making it easier to remove.  When you do that you need a longer cap.

The extra tall BT-50 cap allows you to use a E motor when the engine block was set for a D motor, rather than set the engine block for an E motor and using a spacer. The extra inch of the longer E motor will hang out the back instead.  Please be aware the doing this will shift the center of gravity back, so test for stability before using this in flight.

I would not recommend printing this with PLA due to the heat exposure.  PLA+ might work well enough, ABS for sure.  No supports are needed.  I printed with a .4 nozzle and .2 layer height with the Outer Wall Line Width to .3  For the BT-20 a .2 nozzle might give a smother result but isn't a must.

Thread specs:
BT-20: pitch 1.525mm, base diameter 22.25mm, cap diameter 23.5mm
BT-50: pitch 2.12mm,   base diameter 30.85mm, cap diameter 33.6mm

 

June 28, 2023 UPDATE:  reduced thread diameter setting on the BT-50 cap from 33.85 to 33.6 for a tighter fit so it won't skip threads if overtightened

June 29,2023 UPDATE:  Added extra tall cap, see warning above.

Tags