1 / 3
Media Control | Cable clamp and bottom plate
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The other bottom plates had some fragile nods to lock on the body. So I designed a stronger one, which works perfectly.
- Rating
- 4.75 / 5
- Likes
- 10
- Downloads
- 699
- Makes
- 4
- Views
- 2,284
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
The other bottom plates had some fragile nods to lock on the body. So I designed a stronger one, which works perfectly.
Also I didn't like the huge gap for the cable to go in, so I made a modular cable clamp which locks in that hole, where you can firmly press the cable into. This way it's not needed to reprint the body, but it's a snap-fit add-on.
Print instructions
Bottom plate should be printed around .2, and the cable clamp is tiny enough to print it in 0.08 in under 10 minutes.